Parti

Nessuna parte richiesta.

Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the top side.
  • Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the top side.

Aggiungi Commento

Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the bottom side.
  • Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the bottom side.

  • Remove the warranty sticker across the bottom.

Aggiungi Commento

  • Gently lift off the back and front casing.

  • The outer shell should easily come apart.

Aggiungi Commento

  • Make sure the device screen is face down.

Aggiungi Commento

  • Using the plastic opening tool, wedge the tool underneath the bottom left edge of the hard drive.

  • Raise the bottom edge of the hard drive 15 degrees up from the device.

Aggiungi Commento

  • Place fingers on the IDE connectors and gently slide the hard drive out from the IDE module.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Ryan Sutardji

Membro da: 29/06/2012

171 Reputazione

7 Guide realizzate

Team

Cal Poly, Team 1-4, Regan SU 2012 Membro di Cal Poly, Team 1-4, Regan SU 2012

CPSU-REGAN-SU12S1G4

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 805