Aggiusta la tua roba Comunità Store

Chef's Choice M115 Linkage Pins Replacement

Introduzione

If the sharpening stones become loose or do not apply the correct pressure to the knifes, this could be caused by either broken or missing linkage pins. These pins hold the sharpening stones in place on the motor axle. Replacing a broken or missing pin is a relatively easy process.

Cosa ti serve

  1. Chef's Choice M115 Linkage Pins Replacement, Case: passo 1, immagine 1 di 2 Chef's Choice M115 Linkage Pins Replacement, Case: passo 1, immagine 2 di 2

    • Remove the two rubber feet on the motor side of the device.

    • Remove the five Phillips screws from the bottom of the case.

    • These screws are recessed deep in the device, so a long, thin screwdriver is required.

    Modifica

  2. Chef's Choice M115 Linkage Pins Replacement: passo 2, immagine 1 di 1

    • Remove the two hex-cap screws on the bottom using a pair of pliers.

    Modifica

  4. Chef's Choice M115 Linkage Pins Replacement: passo 3, immagine 1 di 1

    • Carefully flip the device right-side-up while grasping the top and bottom pieces.

    • The white cover should lift off with no resistance. If it does not, ensure all screws were removed in previous step.

    Modifica

  5. Chef's Choice M115 Linkage Pins Replacement: passo 4, immagine 1 di 1

    • Remove the sharpener guard by gently pulling up on it.

    • If the sharpener guard does not come off easily, ensure all screws were removed in step 1.

    Modifica

  6. Chef's Choice M115 Linkage Pins Replacement, Grinding Disc Linkage Pins: passo 5, immagine 1 di 1

    • Remove the motor and shaft assembly from the bottom of the case housing.

    Modifica

  7. Chef's Choice M115 Linkage Pins Replacement: passo 6, immagine 1 di 2 Chef's Choice M115 Linkage Pins Replacement: passo 6, immagine 2 di 2

    • Use a screwdriver to push the pin out of the rod.

    • Use pliers to pull the pin the rest of the way out.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Autore

con 2 altri collaboratori

James Herin

Membro da: 10/27/15

128 Reputazione

1 Guida realizzata

Distintivi: 5

+2 altri distintivi

Team

IUPUI, Team 3-3, Harley Fall 2015 Membro di IUPUI, Team 3-3, Harley Fall 2015

IUPUI-HARLEY-F15S3G3

5 Membri

12 Guide realizzate

Un commento

Where would you obtain new linkage pins. Can I use a similar gauged wire? What, and where can I find a suitable replacement?

Josh Brown - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 19

Tutti i Tempi: 1,754