Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.
Introduzione
If the dial is stuck in any particular position it will be necessary to replace. This guide will show how to locate and replace the dial.
Cosa ti serve
-
-
Place the meter face down, and the back panel and screws can be seen.
-
-
-
Unscrew the two 9mm screws on the back panel using a #0 Phillips screwdriver.
-
-
-
Remove the back panel of the device by lifting upward.
-
Remove the battery from the meter before continuing.
-
-
-
-
Remove the four 7mm Phillips screws holding the circuit board in place.
-
-
-
Carefully remove dial from device by lifting upward.
-
Clean existing dial or replace if necessary.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.