Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the meter face down, and the back panel and screws can be seen.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the two 9mm screws on the back panel using a #0 Phillips screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the back panel of the device by lifting upward.
-
Remove the battery from the meter before continuing.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 7mm Phillips screws holding the circuit board in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently lift the circuit board away from the device casing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The dial is located in the central part of the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully remove dial from device by lifting upward.
-
Clean existing dial or replace if necessary.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate ball bearings. Carefully remove.
-
If both ball bearings are still present, try lubricating ball bearings with multi-use lubricant.
-
If one or both ball bearings are missing, simply replace.
-
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.