Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Archiviate
Guida Archiviata
Questa guida è mantenuta solo per scopi storici. Usa la versione aggiornata della guida per eseguire la riparazione.
Archiviate

Introduzione

The Casio G'zone is an extremely rugged and durable phone, therefore have patience when removing each part as there are many of them. This guide will show you how to replace the motherboard of the phone.

  1. This device is waterproof and well sealed, so it is difficult to open this handset.
    • This device is waterproof and well sealed, so it is difficult to open this handset.

    • Start by opening the cover of the handset.

    • Do not use your nails to open the cover. Use the iFixit Opening Tool (refer to the image).

  2. Move the orange tab to the right side to take out the battery. Remove the battery.
    • Move the orange tab to the right side to take out the battery.

    • Remove the battery.

  3. Using the Phillips #00 screwdriver remove the front and back 5.0 mm screws as shown in the picture. There are four screws in the back and two screws in the front.
    • Using the Phillips #00 screwdriver remove the front and back 5.0 mm screws as shown in the picture.

    • There are four screws in the back and two screws in the front.

  4. Gently remove the side cover from the phone  by lifting up on the corners as shown in the picture. Press down on the screen to help remove the plastic side cover from the phone. Make sure to push gently because the frame is fragile.
    • Gently remove the side cover from the phone by lifting up on the corners as shown in the picture.

    • Press down on the screen to help remove the plastic side cover from the phone.

    • Make sure to push gently because the frame is fragile.

  5. Pull the side front cover off the face of the phone.
    • Pull the side front cover off the face of the phone.

  6. Remove the eight 2.5mm Phillips #00 screws in the holes of the casing. Remove the eight 2.5mm Phillips #00 screws in the holes of the casing. Remove the eight 2.5mm Phillips #00 screws in the holes of the casing.
    • Remove the eight 2.5mm Phillips #00 screws in the holes of the casing.

  7. Gently pull off the motherboard cover.
    • Gently pull off the motherboard cover.

  8. Using the Phillips #00, remove all 2.5 mm screws attached to the motherboard.
    • Using the Phillips #00, remove all 2.5 mm screws attached to the motherboard.

    • Do not touch the integrated circuits in the motherboard.

  9. Gently remove the motherboard with the spudger. Gently remove the motherboard with the spudger.
    • Gently remove the motherboard with the spudger.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 4 persone hanno completato questa guida.

Brett Boehm

Membro da: 25/09/2014

281 Reputazione

2 Guide realizzate

Team

USF Tampa, Team 1-5, Brown Fall 2014 Membro di USF Tampa, Team 1-5, Brown Fall 2014

USFT-BROWN-F14S1G5

3 Membri

3 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 679