Salta al contenuto principale

Introduzione

If your Casio Exilim EX-Z850 is no longer working correctly, you most likely need to replace the motherboard.

The motherboard is responsible for keeping your device functioning properly. It connects all of the principle components of the camera. If the motherboard is not working correctly, everything has the possibility of not working right. If your device continues to malfunction, you should replace the motherboard.

Make sure to power down your camera before you begin.

Ricambi

Nessuna parte specificata.

  1. Casio Exilim EX-Z850 Motherboard Replacement, Motherboard: passo 1, immagine 1 di 1
    • Using the Phillips #00 screwdriver, remove the four screws from the side of the speaker.

  2. Casio Exilim EX-Z850 Motherboard Replacement: passo 2, immagine 1 di 1
    • Using the Phillips #00 screwdriver, remove the four long screws from the bottom of the camera.

    • When reassembling the camera, the longer screws go on the bottom of the camera.

  3. Casio Exilim EX-Z850 Motherboard Replacement: passo 3, immagine 1 di 1
    • Using the Phillips #00 screwdriver, remove the four screws from the side opposite of the speaker.

  4. Casio Exilim EX-Z850 Motherboard Replacement: passo 4, immagine 1 di 3 Casio Exilim EX-Z850 Motherboard Replacement: passo 4, immagine 2 di 3 Casio Exilim EX-Z850 Motherboard Replacement: passo 4, immagine 3 di 3
    • Pry open bottom casing gently after all screws have been removed.

    • With tweezers, carefully remove the ribbon from the LCD screen.

    • Set the bottom casing aside.

  5. Casio Exilim EX-Z850 Motherboard Replacement: passo 5, immagine 1 di 3 Casio Exilim EX-Z850 Motherboard Replacement: passo 5, immagine 2 di 3 Casio Exilim EX-Z850 Motherboard Replacement: passo 5, immagine 3 di 3
    • Pry apart the top casing using tweezers.

    • Set the top casing aside.

    • The bottom left screw on the board is orange and the longest screw.

  6. Casio Exilim EX-Z850 Motherboard Replacement: passo 6, immagine 1 di 2 Casio Exilim EX-Z850 Motherboard Replacement: passo 6, immagine 2 di 2
    • Carefully remove the pieces of black tape on the bottom of the LCD screen that attach it to the frame.

    • Use tweezers to pry the LCD screen off from the opening.

  7. Casio Exilim EX-Z850 Motherboard Replacement: passo 7, immagine 1 di 2 Casio Exilim EX-Z850 Motherboard Replacement: passo 7, immagine 2 di 2
    • Lift the LCD screen and move it to the other side.

  8. Casio Exilim EX-Z850 Motherboard Replacement: passo 8, immagine 1 di 2 Casio Exilim EX-Z850 Motherboard Replacement: passo 8, immagine 2 di 2
    • Using a pair of tweezers, pry off the LCD casing.

  9. Casio Exilim EX-Z850 Motherboard Replacement: passo 9, immagine 1 di 3 Casio Exilim EX-Z850 Motherboard Replacement: passo 9, immagine 2 di 3 Casio Exilim EX-Z850 Motherboard Replacement: passo 9, immagine 3 di 3
    • Flip open the connector holding the ribbon.

    • Use the tweezers to carefully pull out the LCD screen with the ribbon from the camera.

  10. Casio Exilim EX-Z850 Motherboard Replacement: passo 10, immagine 1 di 2 Casio Exilim EX-Z850 Motherboard Replacement: passo 10, immagine 2 di 2
    • Using the Phillips #00 screwdriver, remove two screws on the side where the battery is located.

    • Remove the lanyard loop after the screws come off.

    • Pull the side casing so it becomes dislocated from the top of the camera frame.

  11. Casio Exilim EX-Z850 Motherboard Replacement: passo 11, immagine 1 di 2 Casio Exilim EX-Z850 Motherboard Replacement: passo 11, immagine 2 di 2
    • On the front of the camera near the flash, flip the connector holding the ribbon.

    • Remove the ribbon from the connector.

  12. Casio Exilim EX-Z850 Motherboard Replacement: passo 12, immagine 1 di 3 Casio Exilim EX-Z850 Motherboard Replacement: passo 12, immagine 2 di 3 Casio Exilim EX-Z850 Motherboard Replacement: passo 12, immagine 3 di 3
    • Carefully remove the L-shaped frame from the camera.

    • The L shaped frame is being held in by two plastic bumps and a metal tab at the bottom of the camera.

    • Pop the frame off the bumps and tabs.

    • Potential for device damage: Be careful not to pull off the yellow and orange wire soldered onto the camera.

  13. Casio Exilim EX-Z850 Motherboard Replacement: passo 13, immagine 1 di 2 Casio Exilim EX-Z850 Motherboard Replacement: passo 13, immagine 2 di 2
    • Flip the connector and remove the ribbon cable from the motherboard next to the lens.

  14. Casio Exilim EX-Z850 Motherboard Replacement: passo 14, immagine 1 di 2 Casio Exilim EX-Z850 Motherboard Replacement: passo 14, immagine 2 di 2
    • Remove the frame on the back side of the camera where the LCD screen was.

    • Use the Phillips #00 screwdriver to remove the two screws connecting the frame to the camera.

    • Slowly pry off the frame from the camera.

    • After removing the frame, a plastic piece with two yellow buttons should fall off.

    • Do not pull the plastic piece off as it is soldered to two wires: a yellow and orange one.

  15. Casio Exilim EX-Z850 Motherboard Replacement: passo 15, immagine 1 di 1
    • On the back of the camera where the LCD screen was, remove the 3 screws located behind the lens using the Phillips #00 screwdriver.

  16. Casio Exilim EX-Z850 Motherboard Replacement: passo 16, immagine 1 di 1
    • Remove the large orange ribbon previously held in by screws from the camera.

  17. Casio Exilim EX-Z850 Motherboard Replacement: passo 17, immagine 1 di 1
    • On the backside of the camera where the indicator lamp is located, remove the two screws using the Phillips #00 screwdriver.

  18. Casio Exilim EX-Z850 Motherboard Replacement: passo 18, immagine 1 di 3 Casio Exilim EX-Z850 Motherboard Replacement: passo 18, immagine 2 di 3 Casio Exilim EX-Z850 Motherboard Replacement: passo 18, immagine 3 di 3
    • On the front side of the indicator lamp remove the screw using the Phillips #00 screwdriver.

  19. Casio Exilim EX-Z850 Motherboard Replacement: passo 19, immagine 1 di 2 Casio Exilim EX-Z850 Motherboard Replacement: passo 19, immagine 2 di 2
    • Desolder the lens from the motherboard.

    • Desolder the wire from the motherboard.

    • The motherboard is now detached from the rest of the camera.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Jennifer Roth

Membro da: 28/01/2011

158 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 4-38, Regan Winter 2011 Membro di Cal Poly, Team 4-38, Regan Winter 2011

CPSU-REGAN-W11S4G38

4 Membri

13 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 3,683