Flip the device over to the back side.
  • Flip the device over to the back side.

Aggiungi Commento

Slide the small switch on the back to "MAIN".
  • Slide the small switch on the back to "MAIN".

Aggiungi Commento

  • Slide the battery cover downwards.

  • Pull off the battery cover.

Aggiungi Commento

  • Pull the black tab to remove the battery.

Aggiungi Commento

  • Using the Phillips #00 screwdriver, remove the two screws near the top of the device.

Aggiungi Commento

  • Using the Phillips #00 screwdriver, remove the two screws located inside the battery compartment.

Aggiungi Commento

  • Partially separate the two halves of the case by inserting the tip of a small flat head screw driver into the space between the halves.

Aggiungi Commento

  • Pry the two halves of the case apart with the small flat head screwdriver.

Aggiungi Commento

  • Caution: be careful not to pull out the wires connecting the two halves of the outer case. These wires are necessary for the device to be able to function.

  • Lay the two halves of the outer case next to the central components as shown.

Aggiungi Commento

  • Using the #00 Phillips screwdriver, remove the screws from the corners of the screen. There are 3 screws total.

Aggiungi Commento

  • Lift the tab on the motherboard and pull out the ribbon cable.

  • After the ribbon cable is detached from the motherboard, the touch screen is completely separated from the device.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Ryan Fernandez

Membro da: 03/04/2012

47 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 5-4, Forte Spring 2012 Membro di Cal Poly, Team 5-4, Forte Spring 2012

CPSU-FORTE-S12S5G4

6 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 3

Tutti i Tempi: 658