Canon Powershot SX10 IS LCD Screen Replacement

Introduzione

The LCD screen is a monitor for the camera. It will display the photos before, during, and after capturing a picture. It also is used for changing settings easily. It does not operate in all camera modes. This guide will go through the steps needed to change the LCD screen if it is broken.

Cosa ti serve

Passo 1 Lithium Ion Battery

Canon Powershot SX10 IS LCD Screen Replacement, Lithium Ion Battery: passo 1, immagine 1 di 1

Open the door. Release the catch by sliding it towards the side of the camera.
Then slide the door towards the front of the camera.

Modifica

Passo 2

Canon Powershot SX10 IS LCD Screen Replacement: passo 2, immagine 3 di 3

Remove AA batteries.
Using a fingernail or iFixit opening tools to pry up the battery cradle.
Remove CR1220 battery from the cradle.

Modifica

Passo 3 LCD Screen

Canon Powershot SX10 IS LCD Screen Replacement, LCD Screen: passo 3, immagine 1 di 2

Canon Powershot SX10 IS LCD Screen Replacement, LCD Screen: passo 3, immagine 2 di 2

Remove all four screws on the corners of the screen cover.
Gently pry open the cover with a fingernail or iFixit opening tool.

Modifica

Passo 4

Canon Powershot SX10 IS LCD Screen Replacement: passo 4, immagine 3 di 3

Remove two screws holding on the cover plate on the pivot.
Remove the cover plate using an iFixit opening tool.
You may need to loosen the bottom first, then pry on the top of the cover plate.
Remove the two screws on top of the swivel arm. These two screws will be separated by the pivot point.

Modifica

Passo 5

Canon Powershot SX10 IS LCD Screen Replacement: passo 5, immagine 3 di 3

Remove grounding wire, then continue to remove the screws holding the screen and front cover plate on.
The screen and plate will drop after removing the last screw.

Modifica