Salta al contenuto principale

Canon PowerShot SD1400 IS User Interface Panel Replacement

Cosa ti serve

  1. Canon PowerShot SD1400 IS User Interface Panel Replacement, User Interface Panel: passo 1, immagine 1 di 3 Canon PowerShot SD1400 IS User Interface Panel Replacement, User Interface Panel: passo 1, immagine 2 di 3 Canon PowerShot SD1400 IS User Interface Panel Replacement, User Interface Panel: passo 1, immagine 3 di 3
    • Remove the four 2.0 mm Phillips screws of the camera using the J00 bit from the 54-bit Driver Kit. There are two screws on both sides.

  2. Canon PowerShot SD1400 IS User Interface Panel Replacement: passo 2, immagine 1 di 1
    • Remove the 4.0 mm Phillips screw located on the bottom of the camera.

  3. Canon PowerShot SD1400 IS User Interface Panel Replacement: passo 3, immagine 1 di 1
    • Remove the front face panel of the camera by hand using firm pressure.

    • If one point of the face is stuck to the body, check if there is a screw preventing the front face from coming off.

  4. Canon PowerShot SD1400 IS User Interface Panel Replacement: passo 4, immagine 1 di 1
    • Remove the rear panel of the camera by hand using firm pressure.

  5. Canon PowerShot SD1400 IS User Interface Panel Replacement: passo 5, immagine 1 di 1
    • Remove the user interface panel by hand. The panel may fall out on its own, this is normal.

    • Replace the user interface panel by setting it in position.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Braxton Beal

Membro da: 01/30/18

696 Reputazione

3 Guide realizzate

Team

Baylor, Team S1-G3, Johnson Spring 2018 Membro di Baylor, Team S1-G3, Johnson Spring 2018

BU-JOHNSON-S18S1G3

3 Membri

4 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 240