Introduzione

Screens can be cracked and broken or stop working completely. This guide will show how to replace the screen in the device.

  1. Remove the 2.0 mm Phillips screws on both sides of the camera using the Phillips #00 screwdriver.
    • Remove the 2.0 mm Phillips screws on both sides of the camera using the Phillips #00 screwdriver.

    • There will be 4 total screws that need to be removed, 2 on each side.

    Aggiungi Commento

  2. Remove the 4.0 mm Phillips screw located on the bottom of the camera.
    • Remove the 4.0 mm Phillips screw located on the bottom of the camera.

    Aggiungi Commento

    • Remove the front face panel of the camera.

    • The face can be removed by hand with a firm pressure. If one point of the face is stuck to the body, ensure that there is not a screw remaining at that position to hold it in place.

    Aggiungi Commento

    • Remove the rear panel of the camera.

    Aggiungi Commento

    • Remove the panel of buttons by hand.

    Aggiungi Commento

    • Remove the 3.0 mm Phillips copper colored screw from the top of the camera.

    Aggiungi Commento

    • Remove the 3.0 mm Phillips silver screw from the rear face of the camera, located on the upper right corner.

    Aggiungi Commento

    • Using the plastic spudger, pry the golden film on the front face of the camera off of the microchip.

    • Once removed, a silver screw will be visible from underneath the golden film.

    Aggiungi Commento

    • Remove the 3.0 mm Phillips silver screw using the screwdriver.

    Aggiungi Commento

    • Using the metal spudger, carefully pry the small black tab away from the brown film end of the golden film.

    • Once released, the small black tab will point straight away from the front face of the camera.

    • After releasing the tab, the golden film will no longer be secured to the front face of the camera.

    Aggiungi Commento

    • Unplug the small chip from the face of the camera by carefully inserting the metal spudger underneath the cluster of red wires visible. Then lift the cluster of wires upwards, parallel to the front face of the camera.

    Aggiungi Commento

    • You can now remove the top panel from the camera using your hands with firm pressure.

    Aggiungi Commento

    • Insert the metal spudger underneath the golden film on the front face

    • Lift the golden film on the front face of the camera up and away from its connection

    Aggiungi Commento

    • Remove the screen by sliding the golden film out of the channel and pulling the screen away from the camera.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Braxton Beal

Membro da: 30/01/2018

672 Reputazione

3 Guide realizzate

Team

Baylor, Team S1-G3, Johnson Spring 2018 Membro di Baylor, Team S1-G3, Johnson Spring 2018

BU-JOHNSON-S18S1G3

3 Membri

4 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 6

Tutti i Tempi: 116