Aggiusta la tua roba Comunità Store

Canon PowerShot SD1200 IS Function Button Board Replacement

Introduzione

Use this guide to replace the function buttons on the back of the camera.

Cosa ti serve

  1. Canon PowerShot SD1200 IS Function Button Board Replacement, Front and Rear Covers: passo 1, immagine 1 di 1

    • Remove the battery.

    Modifica

  2. Canon PowerShot SD1200 IS Function Button Board Replacement: passo 2, immagine 1 di 3 Canon PowerShot SD1200 IS Function Button Board Replacement: passo 2, immagine 2 di 3 Canon PowerShot SD1200 IS Function Button Board Replacement: passo 2, immagine 3 di 3

    • Remove the two screws from the side of the camera casing with the strap. (4mm Phillips 00)

    • Remove the two screws from the bottom of the camera. (4mm Phillips 00)

    • Remove the two screws from the right side of the camera opposite the strap. (2mm Phillips 00)

    Modifica

  4. Canon PowerShot SD1200 IS Function Button Board Replacement: passo 3, immagine 1 di 2 Canon PowerShot SD1200 IS Function Button Board Replacement: passo 3, immagine 2 di 2

    • Pull off the front cover.

    • If the top of the cover sticks, use gentle downward pressure on the retention clips above the lens to release.

    • Remove the back cover.

    Modifica

  5. Canon PowerShot SD1200 IS Function Button Board Replacement, Function Buttons: passo 4, immagine 1 di 1

    • Use the spudger to lift the tab on the Zero Insertion Force (ZIF) connector located at the top of the function button board.

    • Be sure you are prying up on the hinged retaining flap, not the connector itself.

    • Slide out the ribbon cable from the connector.

    Modifica

  6. Canon PowerShot SD1200 IS Function Button Board Replacement: passo 5, immagine 1 di 1

    • Remove the top screw from the function button board. (3.5mm Phillips 00)

    • Remove the bottom screw from the function button board. (2.5mm Phillips 00)

    Modifica

  7. Canon PowerShot SD1200 IS Function Button Board Replacement: passo 6, immagine 1 di 1

    • Lift out the function button board.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 4 altri collaboratori

Jeff Casper

Membro da: 09/15/16

848 Reputazione

7 Guide realizzate

Distintivi: 18

+15 altri distintivi

Team

USF Tampa, Team 17-5, Blackwell Fall 2016 Membro di USF Tampa, Team 17-5, Blackwell Fall 2016

USFT-BLACKWELL-F16S17G5

3 Membri

7 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 18

Tutti i Tempi: 232