Salta al contenuto principale

Parti

Nessuna parte specificata.

  1. Unscrew five Phillips screws using a #0 Phillips screwdriver. One screw is on upper right corner of the back panel.
    • Unscrew five Phillips screws using a #0 Phillips screwdriver.

    • One screw is on upper right corner of the back panel.

    • The other four screws are on the bottom of the camera.

  2. Open the memory card cover by moving the slide switch toward the top end of of the camera.
    • Open the memory card cover by moving the slide switch toward the top end of of the camera.

    • Remove the memory card from the slot.

  3. Skip the upgrade.

    Ottieni $10 di sconto su $50 con
    SKIPANDSAVE10

    Save Now

    Skip the upgrade.

    Take $10 off $50 with
    SKIPANDSAVE10

    Save Now
  4. Remove the rear cover from the rest of the camera.
    • Remove the rear cover from the rest of the camera.

    • This may require gentle rocking of the case to free it.

  5. Unscrew the four Phillips screws from the side of the casing and one screw from the bottom using a #0 Phillips screwdriver. Unscrew the four Phillips screws from the side of the casing and one screw from the bottom using a #0 Phillips screwdriver.
    • Unscrew the four Phillips screws from the side of the casing and one screw from the bottom using a #0 Phillips screwdriver.

  6. Free the front cover from the rest of the camera.
    • Free the front cover from the rest of the camera.

    • The cover may require gentle rocking to remove.

Linea Traguardo

Un'altra persona ha completato questa guida.

Nathan Balcom

Membro da: 21/01/2010

81 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 16-28, Maness Winter 2010 Membro di Cal Poly, Team 16-28, Maness Winter 2010

CPSU-MANESS-W10S16G28

4 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,449