Introduzione

In this guide, we will be showing you how to remove the flash dial in order to replace it.

Parti

Nessuna parte richiesta.

  1. Remove the five 2mm  Phillips #000 screws that are under the screen of the camera.
    • Remove the five 2mm Phillips #000 screws that are under the screen of the camera.

  2. Remove the two 3mm Phillips #000 screws under the AV-out digital flap.
    • Remove the two 3mm Phillips #000 screws under the AV-out digital flap.

    • Remove the two 3 mm Phillips #000 screws from the side of the camera.

  3. Remove the two 3 mm Phillips #000 screws on the side of camera with the flash toggle.
    • Remove the two 3 mm Phillips #000 screws on the side of camera with the flash toggle.

  4. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  5. Remove the four 4 mm Phillips #000 screws from the plate on the bottom of the camera.
    • Remove the four 4 mm Phillips #000 screws from the plate on the bottom of the camera.

  6. Remove the back plate.
    • Remove the back plate.

  7. Remove the three 3 mm Phillips #000 screws around the dial.
    • Remove the three 3 mm Phillips #000 screws around the dial.

  8. Using  the nylon spudger, gently lift the ZIF tab. Disconnect the ribbon cable that connects the dial to the motherboard.
    • Using the nylon spudger, gently lift the ZIF tab.

    • Disconnect the ribbon cable that connects the dial to the motherboard.

    • Remove the dial from the device.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 31

Tutti i Tempi: 165