Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Open the cover on the bottom of the camera.
-
Remove the battery.
-
Remove the memory card.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the 1.5mm hex screwdriver, remove the screws from the end cap.
-
Remove the end cap.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the 1.5mm hex screwdriver, remove the four screws from the rear of the case.
-
Remove the screw from the bottom of the case.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the Philips #00 screwdriver, remove the two screws on the left side of the case.
-
Remove the rear of the case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the Phillips #00 screwdriver, remove the two screws holding the LCD screen in place.
-
Remove the small metal bar holding in the LCD screen.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the spudger under the LCD screen and pry it off. Since the screen is glued down with adhesive, some effort may be required.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently disconnect the two ribbon wires from the camera. Use tweezers or a spudger to remove them.
-
To remove these cables, pull them straight out of their sockets.
-
When reassembling, be sure you plug these cables into the sockets fully. You will hear a faint click when they are fully in.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a guitar pick or spudger to pry the front and back of the metal case off the LCD screen.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.
2 Commenti
How do you take the shutter button part off ?