Introduzione

This guide will allow you to repair or replace the viewfinder of the Canon PowerShot A95.

Locate the black “BATT OPEN” button on the underside of the camera.
  • Locate the black “BATT OPEN” button on the underside of the camera.

  • Slide the black “BATT OPEN” button to the right.

  • Remove four AA batteries from the device.

Aggiungi Commento

Locate and remove three screws on the underside of the camera (3x small Phillips head).
  • Locate and remove three screws on the underside of the camera (3x small Phillips head).

  • Keep all screws separated by step and in a place where they will not be lost.

  • Tip: a jewelry tray can be helpful for keeping all the screws secure and separated.

Aggiungi Commento

  • Locate and remove two screws on the same side of the camera as the marked A/V port (2x small Phillips head).

Aggiungi Commento

  • Using the blue plastic opening tool, remove the plastic covering you just removed screws from on the left side of camera.

  • Gently pull up around edges until the plastic flap inside is pulled out and the piece swings upward (piece should pull free).

Aggiungi Commento

  • Remove indicated screw holding front of camera in place.

Aggiungi Commento

  • Push against the memory card cover in order to pull it outward toward you to reveal a screw underneath.

  • Remove this screw (Phillips head).

Aggiungi Commento

  • Re-open the battery cover. Locate and remove the three screws under the battery cover (3x small, long Phillips head).

  • Tip: using a magnetic screwdriver is very helpful, as the screws are difficult to reach.

Aggiungi Commento

  • Locate and lift the shutter button, speaker, and option wheel from the top of the camera.

  • Note: DO NOT pull too hard as there is a plug connecting the speaker to the camera.

  • The memory card cover will pop off in this process.

  • Note the original location next to the loose pieces of hardware. This piece will remain attached to the device, so do not try to fully detach it.

Aggiungi Commento

  • Locate and press the button on the lower left corner of the lens.

  • Separate the back casing from the front casing of the camera.

  • Removing the casing may require the use of a spudger.

Aggiungi Commento

  • Twist the LCD screen so it is perpendicular to the camera and snap the back casing off.

  • This piece will remain attached to the device, so do not try to fully detach it.

Aggiungi Commento

  • Carefully jiggle the viewfinder until it comes loose from the camera.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Elizabeth Kisner

Membro da: 24/09/2013

101 Reputazione

1 Guida realizzata

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 10

Tutti i Tempi: 1,112