Introduzione

This guide will teach you how to replace a faulty speaker.

Parti

Lift the printer lid up as shown in the photo.
  • Lift the printer lid up as shown in the photo.

Aggiungi Commento

Locate and remove the two 10mm side screws. There is one on each side.
  • Locate and remove the two 10mm side screws. There is one on each side.

Aggiungi Commento

  • Unhook the plastic panel from the printer starting from the top.

    • You may need to wiggle the panel a bit to loosen it.

  • To remove the bottom part of the paneling gently lay the printer on its back.

    • The scanner lid needs to be supported when moving the printer

Aggiungi Commento

  • Gently unhook the right side paneling (as looking at the printer's front face) from the printer.

    • Use a gentle back and forth motion to wiggle the hooks out.

Aggiungi Commento

  • Lay printer on its left side for better access to the speaker.

    • Note: The scanner lid needs to be supported when moving the printer

Aggiungi Commento

  • Locate the black 7mm screw holding the speaker in place.

  • Using a Phillips head screw driver, unscrew the 7mm screw.

Aggiungi Commento

  • Locate the red and black wires connected to the speaker.

  • Undo the white clip holding the wires in place by pinching the tab on the top.

  • Remove the red and black wires from the wire bundle.

  • When replacing the old speaker, do not touch any part of the new speaker that is not metal other than the wires. Doing so could damage the speaker.

  • Lift out the speaker

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Helena Yanez

Membro da: 29/09/2013

446 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 13-1, Forte Fall 2013 Membro di Cal Poly, Team 13-1, Forte Fall 2013

CPSU-FORTE-F13S13G1

5 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 11

Tutti i Tempi: 917