Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Canon EOS Rebel XS LCD Replacement

Cosa ti serve

  1. Canon EOS Rebel XS LCD Replacement, Latch Side Cover: passo 1, immagine 1 di 1
    • Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.

  2. Canon EOS Rebel XS LCD Replacement: passo 2, immagine 1 di 1
    • On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.

    • Pry up the panel; starting from the front/bottom corner, as indicated.

    • There's a concealed lip, under the opposite edge.

  3. Canon EOS Rebel XS LCD Replacement, Back Cover: passo 3, immagine 1 di 1
    • Remove the three long black screws from the bottom using a #00 Phillips screwdriver.

    • Use tweezers to lift the panel.

  4. Canon EOS Rebel XS LCD Replacement: passo 4, immagine 1 di 1
    • Once you have detached the back cover, use a pair of tweezers to lightly pull on strap found connecting the back cover to the camera.

  5. Canon EOS Rebel XS LCD Replacement, LCD: passo 5, immagine 1 di 1
    • Use the tweezers to gently remove the straps (in the teal box).

    • Use the Phillips Screwdriver to remove the four screws (in the red dots).

    • Use your fingers to remove the silver plate.

  6. Canon EOS Rebel XS LCD Replacement: passo 6, immagine 1 di 1
    • Use the Spudger on the edges of the screen.

    • Once one end is lose, use the tweezers to lift the screen.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Daniel Bussone

Membro da: 01/28/11

1.251 Reputazione

11 Guide realizzate

Team

Cal Poly, Team 3-41, Regan Winter 2011 Membro di Cal Poly, Team 3-41, Regan Winter 2011

CPSU-REGAN-W11S3G41

2 Membri

21 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 5

Tutti i Tempi: 7,284