Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lay the camera on its back so that the card/battery door is facing you.
-
Using your fingernail, slide the tab on the battery door up to release the battery door latch.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the now free card/battery door to reveal the battery compartment.
-
Push the gray lever to the right side so that the battery can be removed and replaced with a new one.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the camera so that the back is facing to your right.
-
Remove the 5mm Phillips #000 screw above the rubber USB port cover.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the rubber piece.
-
Unscrew the two screws under the rubber cover to completely remove the rubber cover piece.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn your camera so that the bottom is facing you.
-
Remove the 5mm Phillips #000 screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Now turn the camera so that the front is facing towards your right.
-
Remove the two remaining 5mm Phillips #000 screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Now that all of the exterior screws have been removed, grip the camera firmly on both sides.
-
Gently pry the back panel from the main body of the camera.
-
Annulla: non ho completato questa guida.
Altre 4 persone hanno completato questa guida.