Introduzione

This guide will instruct you how to install the flash on your camera.

  1. Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
    • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

    Aggiungi Commento

  2. Using your finger, peel back the textured grip so the components are separated.
    • Using your finger, peel back the textured grip so the components are separated.

    Aggiungi Commento

    • Using the flat end of a spudger, loosen the connection between the front panel and the device.

    • Remove the front panel using your hands.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Pop the flash up with your thumb

    Aggiungi Commento

    • Unscrew the two screws on the front of the flash near the bulb cover.

    Aggiungi Commento

    • Close the flash.

    • Lift the flash cover off.

    Aggiungi Commento

    • Pull off yellow capacitor from flash wiring.

    Aggiungi Commento

    • Remove white cocking with a razor blade, and then unsolder connection.

    Aggiungi Commento

    • Remove the flash cover to access the flash bulb.

    • After wires are unsoldered, slide flash bulb out from housing.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Zach

Membro da: 04/04/2012

40 Reputazione

8 Guide realizzate

Team

Cal Poly, Team 14-9, Forte Spring 2012 Membro di Cal Poly, Team 14-9, Forte Spring 2012

CPSU-FORTE-S12S14G9

5 Membri

12 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 6

Tutti i Tempi: 1,729