Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Take the LCD out of its place to expose the Phillips #PH00 screws.
-
Remove the two 2.5 mm Phillips #PH00 black screws on both sides of the LCD screen.
-
Next remove the two 3 mm Phillips #PH00 black screws near both sides of the base where the screen swivels.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a plastic opening tool, carefully pry off the back cover of the LCD.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 3 mm Phillips #PH00 silver screw on the side of the screen.
-
Turn the screen to remove the second 3 mm Phillips #PH00 silver screw.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the tweezers, carefully disconnect the rear connector by pulling it away from the screen.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 2.5 mm Phillips #PH00 silver screws using the PH00 screwdriver.
-
Using the plastic Spudger opening tool, carefully lift up on the medal tabs next to where the screws were located.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Finally, remove the LCD screen by grabbing the clear plastic tab and lifting it carefully.
-
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.