Introduzione

In this guide we will replace the power cord and the transformer The transformer is the large, heavy device that converts the relatively high 220V input voltage into a lower voltage for the amplifier.

Remove 2 screws from each side of the amplifier.
  • Remove 2 screws from each side of the amplifier.

Aggiungi Commento

Remove 2 screws on rear of device. Slide top cover up and back from main case.
  • Remove 2 screws on rear of device. Slide top cover up and back from main case.

Aggiungi Commento

  • Remove 3 screws on bottom of case.

  • Remove 13 screws on rear panel.

    • Do not move the rear panel too far, as the power cord is still connected.

Aggiungi Commento

  • Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.

  • It may require some wiggling, but it should slip out of the hole and then off of the cord.

Aggiungi Commento

  • Carefully de-solder ends of power cord from circuit board.

  • Keep track of the colors of the cords. The brown cord leads to the L on the circuit board, and this cord will lead to a fuse in the power plug. The blue cord leads to the N on the board.

  • Finally, pull the power cord through the rear panel to completely remove it.

Aggiungi Commento

  • To remove the transformer the motherboard must be removed. This is to gain access to the solder on the power cords. -See guide for removing motherboard.

  • Remove the 4 nuts holding down the transformer bracket using a 7mm nut driver or socket.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Colby

Membro da: 15/04/2010

284 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 28-36, Regan Spring 2010 Membro di Cal Poly, Team 28-36, Regan Spring 2010

CPSU-REGAN-S10S28G36

4 Membri

3 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 12

Tutti i Tempi: 5,559