Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Helping Hand 1/4" screwdriver to unscrew the six 3/16" corner screws.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Close the back cover and then flip the device over and separate the top half from the bottom half as shown.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently pull out the ribbon cable from the circuit board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two-pin plastic connector from the circuit board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
On the top portion of the device there are four grey clips locking the faceplate in place. The two top clips are circled in the image. The two others are located in the other corners of the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the clips inward two at a time, first the top then the bottom, to snap the face plate off.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.