Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove three 8mm screws from the left side of the device.
-
Remove four 8mm screws from the right side of the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Apply pressure on the SD card to pop it out of the port.
-
Remove the card by pulling it out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Press down on the top cover of the device and slid it towards you until you see a slight gap created.
-
Lift the top cover off.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the body case back away from the bottom.
-
Pull up the body case to remove it from the bottom.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 8mm screws at each corner of the motherboard with a JIS #0 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the black adhesive that covers the four screws.
-
Remove the four screws.
-
Flip the motherboard over and remove the heat sink by pulling up.
-