Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Braven BRV-1M Sub-woofer Cone Replacement

Cosa ti serve

  1. Braven BRV-1M Sub-woofer Cone Replacement, Sub-woofer Cone: passo 1, immagine 1 di 1
    • To remove the outer rubber casing use a 3mm Hex bit to remove the 4 large 12mm Hex screws on both sides, found on the bottom part of the device.

  2. Braven BRV-1M Sub-woofer Cone Replacement: passo 2, immagine 1 di 1
    • Using the Metal Spudger, carefully pry each side of the rubber casing away from the device.

    • A little resistance should be felt, but not enough to bend the spudger.

  3. Braven BRV-1M Sub-woofer Cone Replacement: passo 3, immagine 1 di 1
    • To remove the hard inner plastic casing, use a Phillips #00 head bit to remove the 16 small 9mm screws surrounding the subwoofer on the top side of the device.

  4. Braven BRV-1M Sub-woofer Cone Replacement: passo 4, immagine 1 di 1
    • Carefully lift away the broken sub-woofer plate of the device. Replace with functioning sub-woofer plate.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Erik Oliva

Membro da: 02/14/18

607 Reputazione

6 Guide realizzate

Team

USF Tampa, Team S2-G1, Eyestone Spring 2018 Membro di USF Tampa, Team S2-G1, Eyestone Spring 2018

USFT-EYESTONE-S18S2G1

4 Membri

6 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 4

Tutti i Tempi: 171