Introduzione

Use this guide to disassemble a Braun hld6 hairdryer or to gain access to malfunctioning parts that need to be replaced.

Parti

Nessuna parte richiesta.

  1. Make sure the hairdryer is not plugged in!
    • Make sure the hairdryer is not plugged in!

    • Take out the two 32.3 mm Phillips #1 screws from the outside.

    • Take out the one 6.0 mm Phillips #1 screw.

    Aggiungi Commento

  2. Pry apart the two main bodies.
    • Pry apart the two main bodies.

    Aggiungi Commento

    • Take out the last outside screw, a 6.0 mm PH #1, to remove the grid.

    Aggiungi Commento

    • Take out the 14.6 mm Flathead screws that hold the power cord in place.

    • Take out the 18.2 mm Flathead screws that hold the buttons in place.

    • Take out the 27.1 mm Flathead screws that keep the motor in place.

    Aggiungi Commento

    • Take out the interior.

    Aggiungi Commento

    • Loosen the 2 flathead screws in the terminal block closest to the power cord.

    • Pull out the power cord.

    Aggiungi Commento

    • Loosen the flathead screws and remove the wires from the button holder. Remove the button holders. When you unscrew the wire opposite to where the yellow wire is connected, you can slide the button off of the middle wire connected to the motor.

    Aggiungi Commento

    • Lastly, remove the yellow wire.

    Aggiungi Commento

    • Take out the diode.

    Aggiungi Commento

    • Remove the flathead screws from the back of the motor.

    • To take apart the remaining parts, desoldering is required.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 2

Tutti i Tempi: 62