Aggiusta la tua roba Comunità Store

Braun Series 7 790cc-7 Charging Base Wire Harness Replacement

Introduzione

The charging base wire harness is essential to the function of the Braun Series 7 790cc-7 charging base. Many consumers may discard the charging base if it cannot be used to charge and clean the razor. This can be expensive but by replacing a faulty charging harness the razor can be used with the charging base again. With the use of this Replacement Guide, one can easily change the charging base harness if required.

Cosa ti serve

  1. Braun Series 7 790cc-7 Charging Base Wire Harness Replacement, Charging base wire harness: passo 1, immagine 1 di 1

    • Remove the cleaner cartridge from the charging base.

    Modifica

  2. Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: passo 2, immagine 1 di 3 Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: passo 2, immagine 2 di 3 Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: passo 2, immagine 3 di 3

    • Depress the 4 tabs while lightly pulling the cover from the base.

    • Next, depress the 2 molded tabs while still pulling the cover from the base.

    Modifica

  4. Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: passo 3, immagine 1 di 1

    • Press inward on the side charging port while pulling cover from the base to separate.

    Modifica

  5. Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: passo 4, immagine 1 di 2 Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: passo 4, immagine 2 di 2

    • Remove side charging port by prying tabs outward and rotating port upward.

    Modifica

  6. Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: passo 5, immagine 1 di 2 Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: passo 5, immagine 2 di 2

    • Remove charging terminals by inserting a spudger from bottom the and sliding terminals up.

    Modifica

  7. Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: passo 6, immagine 1 di 2 Braun Series 7 790cc-7 Charging Base Wire Harness Replacement: passo 6, immagine 2 di 2

    • Remove solder from circuit board and remove charging harness.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Autore

con 2 altri collaboratori

Ian Hayes

Membro da: 11/07/17

216 Reputazione

2 Guide realizzate

Distintivi: 6

+3 altri distintivi

Team

IUPUI, Team S3-G6, Harley Fall 2017 Membro di IUPUI, Team S3-G6, Harley Fall 2017

IUPUI-HARLEY-F17S3G6

3 Membri

5 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 10

Tutti i Tempi: 1,064