Flip the mouse over and peel off the stickers on the perimeter of the bottom of the mouse
  • Flip the mouse over and peel off the stickers on the perimeter of the bottom of the mouse

my mouse sucks i peeled off the tape and there is a layer of something blocking the the screw it is a gaming mouse and i got it 2 weeks ago

Nathan Swercewski - Replica

Use the Phillips #1 screwdriver to unscrew the six round head screws on the bottom of the mouse. Those marked with squares are 9 mm in length, the rest are 5 mm in length.
  • Use the Phillips #1 screwdriver to unscrew the six round head screws on the bottom of the mouse. Those marked with squares are 9 mm in length, the rest are 5 mm in length.

Aggiungi Commento

  • Grab the top shell of the mouse and lift up to remove.

Aggiungi Commento

  • The capacitors on this board can release stored electrical energy if touched.

  • Touch your capacitor discharge tool to the capacitor leads on the board to release the stored energy. If leads are inaccessible, wait until you've removed the board from the mouse body.

Aggiungi Commento

  • To remove the white wire connector on the bottom board, use a spudger underneath the white plug and pop it out (this disconnects the upper board from the lower board).

Aggiungi Commento

  • Locate the 5 mm silver flat head mounting screws (2) to the left and right of the scroll wheel and remove with the Phillips #1 screwdriver.

Aggiungi Commento

  • Locate the snaps on the bottom corners of the mouse side panels and pop the indicated snaps out, using a spudger or your fingernail.

Aggiungi Commento

  • Repeat Step 6 for the opposite side panel in order to detach both sides from the base of the mouse.

Aggiungi Commento

  • Grab the sides of the mouse and lift them up to detach from the base of the mouse.

Aggiungi Commento

  • Pop the scroll wheel out of the snap holding it in place. You can use your finger or a spudger to do so.

Aggiungi Commento

  • Locate the four 5 mm black flat head screws on the corners of the bottom board.

  • Unscrew these four black screws.

Aggiungi Commento

  • Lift the bottom board up to remove from its mounting posts. This will separate it completely from the bottom panel of the mouse.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

royceeklund

Membro da: 18/01/2013

16 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 18-36, Regan Winter 2013 Membro di Cal Poly, Team 18-36, Regan Winter 2013

CPSU-REGAN-W13S18G36

3 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 5

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 59

Tutti i Tempi: 2,766