Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Rimuvoi la gomma che copre la batteria e rimuovi le quattro viti T8 Torx cerchiate da 6.0mm.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert the Metal Spudger between the rubber edge on the grille and the aluminum casing.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slowly pry up the grille until the two tabs shown pop out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The grille is attached to the speaker with double sided sticky tape. To remove the grill gently pull upward while keeping tension to the right.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 15.0 mm screws on the left and the four 9.0 mm screws on the right using the T8 Torx Screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the circuit board by pushing it with your index finger in the direction shown while using a nylon or metal spudger to lift it up and out of place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully pull on the battery cover until the rubber tab slides out of the aluminum casing.
-
Annulla: non ho completato questa guida.
Altre 7 persone hanno completato questa guida.
3 Commenti
@rajpotus: I had the same problem. If the little rubber tab is not damaged (mine was fine), you should be able to follow these instructions to replace it. But I have these comments on the instructions:
1) You do NOT need to remove the front grill. I have no idea why they suggest you do that here.
2) I think the reason you remove the battery is to make sure the circuit board has zero power on it when you work on it — otherwise a touch of the screwdriver to an unlucky spot on the board might short/burn something out. But I don’t think there’s any mechanical reason to remove it.
3) Once you pop off the back grill cover, you should be able to slide the tab through the slot and coax it up (maybe with a tooth-pick and/or tweezers) on top of the circuit board, but it’s probably better to unscrew the circuit board (as directed here) which makes it easier to push the rubber tab through. Then slide the circuit board back under the tab and screw it back into place.