Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pinch the two release tabs on the sides of the battery, and slide the battery out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
After removing the battery pack, locate the clip that connects the two halves of the outer casing shown in the picture. Remove the clip using angled tweezers or a similar tool. Save the clip for reassembly.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the eight 5.5 mm screws as shown in the picture.
-
Remove each screw using a small Phillips head screw driver. Save all the screws for reassembly.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Starting at the rear of the drill, use a wedge to separate the two halves of the outer case at the parting line.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift up the metal tab as shown in the first picture to free the trigger assembly.
-
Gently dislodge the motor and trigger assembly from the drill case. Remove the components as one piece, shown in the second picture.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Firmly secure the motor assembly in place. Using a set of pliers, carefully pull the black wire connector away from the motor. Repeat this action with the red wire connector.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once the wires have been disconnected, separate the trigger mechanism from the motor assembly.
-
Place your hands on each end of mechanism and carefully pull apart the assembly in order to separate the gearbox from the motor.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.