Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pinch the two release tabs on the sides of the battery, and slide the battery out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the clip that binds the two halves of the outer casing together on the rear edge of the battery shaft. Remove the clip with the angled tweezers.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the eight 5.5 mm screws on the upwards facing side of the drill.
-
Remove each screw using the T8 Torx screwdriver and place them together in a safe place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the upper portion of the case from the outer portion of the case using a metal spudger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Dislodge the motor assembly from the casing.
-
Remove the gearbox from the motor assembly.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.