Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the T20 Torx Screwdriver, remove the four 15.6 mm screws securing the top cover to the sander.
-
Lift the top off of the sander.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the T20 Torx Screwdriver, remove the two 15.6 mm screws securing the cable clip to the motor housing.
-
Lift the cable clip and cord from motor housing.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the On/Off switch out of the device
-
Remove the gray and purple wires
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the gray, brown, and clear wires by pulling on the wire terminals.
-
Lift the Governor out of the housing.
-