If the rear speaker on your Blackberry 7520 is broken, look here to install a new one.


Nessuna parte richiesta.

Turn the phone upside down.
  • Turn the phone upside down.

  • Push down on the black button on the back of the phone to slide the rear panel off.

  • The battery should be visible now.

Aggiungi Commento

Hold the BlackBerry in one hand face-up with the screen facing towards you.
  • Hold the BlackBerry in one hand face-up with the screen facing towards you.

  • Gently smack the phone against your hand to dislodge the battery.

Aggiungi Commento

  • Use a T6 Torx screwdriver to remove the six screws located on the rear of the phone.

Aggiungi Commento

  • Use a pick or plastic iPod opening tool to push the clips, that are holding the rear casing. Apply a firm pressure at a forty-five degree angle to dislodge the clips.

  • Applying too much pressure could break the plastic clips and permanently damage the casing, so be careful.

Aggiungi Commento

  • Repeat the process of unlatching the clips for the top section of the Blackberry.

Aggiungi Commento

  • Do not try to pull the two pieces apart. You may tear the antenna cable. Instead, fold the two pieces open to avoid stress on the cable.

Aggiungi Commento

  • Separating the two halves allows you to access the speaker. Which is located in the front half of the case.

Aggiungi Commento

  • Insert a plastic opening tool between the speaker and the case. Then pry the speaker out.

  • To reinsert the speaker, align the blue notch to the blue stud. Then the red notch to the red stud. As shown in the last picture.

Aggiungi Commento


To reassemble your device, follow these instructions in reverse order.


Membro da: 18/01/2010

31 Reputazione

7 Guide realizzate


Cal Poly, Team 5-7, Forte Winter 2010 Membro di Cal Poly, Team 5-7, Forte Winter 2010


5 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 2,373