Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove four screws total on the back of the phone casing near edge of battery area.
-
Two screws that are closer to the top of the phone are protected by plastic stoppers. Remove them then remove the screws.
-
There are two more screws on either side of where the battery was located. remove them as well.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once the keypad is removed, the buttons on the sides of the phone will fall out.
-
You will need to loosen the board from the right side opposite the charging ports.
-
Pull gently towards the right side so the ports clear the plastic casing.
-
Gently flip the board over to the left.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
On the back of the circuit board you will find a small rectangular blue piece with a black 'L' shape in the middle.
-
Gently detach this from the back of the main board.
-
Now you may fully remove the main board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
What is left inside the phone is the roller ball.
-
Gently use the plastic blue tool to detach it from the frame.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.