Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.
Introduzione
The purpose is to remove both the main circuit board and the roller ball unit from the main frame of the phone.
Cosa ti serve
-
-
There are four screws total on the back of the phone casing near edge of battery area.
-
The two closer to the top of the phone are protected by plastic stoppers. Remove them then remove the screws.
-
There are two more screws on either side of where the battery was located. remove them as well.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.