Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Begin by removing the back panel; this can be done by pressing the silver button on the backside of the Blackberry 8100, while simultaneously sliding the back panel off.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the battery located directly below back panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a 1.5 mm Hex screwdriver, remove the two screws that hold the two panels together.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the spudger, pry off the small portion of the casing located at the bottom of the phone.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the spudger, pry off the side casings one at a time by wedging it between the inner casing and the sides.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a 1.5mm Hex screwdriver, unscrew the two screws, located on the front of the phone, that connect the back and front panels.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the spudger, pry off the back body panel by wedging the spudger in between the front and back panels on the side face. Remove the back body panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Separate the logic board from the front panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently remove the keyboard from front casing. It should snap out of place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
After removing the logic board, place spudger between the logic board and screen and remove the screen, sliding it slowly away.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.