Introduzione

This is a guide on how to replace the logic board on your Blackberry 7510.

Parti

Nessuna parte richiesta.

Remove the battery cover and battery before continuing.
  • Remove the battery cover and battery before continuing.

  • Remove the six T6 Torx screws on the back of the phone.

  • Make sure to keep the screws somewhere that they will not get lost.

Aggiungi Commento

Using your finger nail or a spudger, carefully pry up the back cover.
  • Using your finger nail or a spudger, carefully pry up the back cover.

  • Begin in one spot and slowly circle around the device as you pry up all of the back cover.

Aggiungi Commento

  • Lift off the back cover.

Aggiungi Commento

  • Remove the two T6 screws.

Aggiungi Commento

  • Remove the daughterboard.

  • Remove the exposed vibration motor.

Aggiungi Commento

  • Using the T6 Torx screwdriver, remove the top screw.

Aggiungi Commento

  • Using your spudger, carefully pry off back plate.

  • Use the same technique as with the plastic back cover. Circle around the back plate until all of it is pried up.

Aggiungi Commento

  • Remove the front cover and keypad.

Aggiungi Commento

  • Remove one T6 Torx screw in the front bottom right of the board.

Aggiungi Commento

  • Carefully pry the screen from the board with your spudger.

  • After prying it up, remove the screen from the board.

Aggiungi Commento

  • Unscrew center T6 Torx screw in the center of the logic board.

  • Remove the logic board from the phone.

  • Replace with new logic board.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Neil Johnson

Membro da: 24/01/2010

12 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 14-44, Regan Winter 2010 Membro di Cal Poly, Team 14-44, Regan Winter 2010

CPSU-REGAN-W10S14G44

4 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,781