Introduzione

How to replace the LCD and reassemble the Blackberry 7105t

Strumenti

Nessun attrezzo richiesto.

  1. With the back of the device facing you, press down on the button while sliding the battery casing away from the speaker to remove it.
    • With the back of the device facing you, press down on the button while sliding the battery casing away from the speaker to remove it.

    Aggiungi Commento

  2. Use a plastic opening tool or fingernails to unclip the two hinges of the speaker covering and remove it.
    • Use a plastic opening tool or fingernails to unclip the two hinges of the speaker covering and remove it.

    Aggiungi Commento

    • Remove the battery by pushing against it from the right and then pulling towards you.

    Aggiungi Commento

    • Remove the four screws indicated in the picture with a #T6 Torx Bit screwdriver and set them aside.

    Aggiungi Commento

    • Use a plastic opening tool or your fingernails to remove the plastic backing.

    • Start with the seam indicated in the picture and slide the plastic opening tool until the case is seperated.

    Aggiungi Commento

    • Unscrew the four screws indicated in the picture with #T6 Torx Bit screwdriver.

    • Place the four screws released from the phone in a plastic bag.

    Aggiungi Commento

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • The black battery casing and logic board can now be separated for the following steps.

    Aggiungi Commento

    • The silver piece is not attached to the logic board in any way, and can be taken off by lifting it up with plastic opening tools.

    • Warning: Some of the phones have an adhesive between the silver part and the battery housing, so it could stick to the black piece you just removed.

    Aggiungi Commento

    • With the screen facing you, you will be able to see a small grey plastic clip.

    • Use a plastic opening tool to unfasten the clip as shown.

    Aggiungi Commento

    • Flip the logic board over to the other side.

    • Use a plastic opening tool unclip the top two clips shown in red, and then the bottom two clips. This releases the screen.

    • Flip logic board over and remove screen.

    • Make sure to hold the screen, it could fall after being unclipped.

    Aggiungi Commento

    • NOTE: If you are not replacing the LCD screen, move on to the next step.

    • After removing the original screen, keep the logic board facing you the way it was.

    • Take the new screen and slip the flexible piece of connecting circuitry under the grey plastic flap that you pried up in step 10.

    • Handle the screen carefully as it is fragile.

    • Push it gently but firmly until it does not move any further to the left, then close the grey flap.

    • After this, the screen can be pushed down and clicked back into place.

    • To reassemble the phone, reverse instructions.

    Aggiungi Commento

    • Handle the screen carefully as it is fragile.

    • Push the screen gently but firmly until the connecting cable does not move any further to the left, then close the grey flap.

    • Push the screen down until it clicks into place.

    • Be sure to check that the white clips are aligned on each side before continuing.

    Aggiungi Commento

    • Reattach Keyboard.

    • Flip phone over to the backside.

    • Make sure black clips on the back of the logic board click and are aligned.

    Aggiungi Commento

    • Reattach black plate with the four screws

    Aggiungi Commento

    • Reattach the front and back covers starting with the front.

    • Make sure side clips are not overlapping on the outside.

    Aggiungi Commento

    • Screw and tighten the four screws on the back side of the phone.

    Aggiungi Commento

    • Reattach speaker covering as shown.

    • Using the Ipod opening tool, press the two clips on the top side of the speaker covering until they slip into the notch.

    • Warning: The clips are fragile, do not apply excessive force.

    Aggiungi Commento

    • Insert Battery

    • Replace cover

    Aggiungi Commento

Linea Traguardo

JamOrd5

Membro da: 15/11/2012

101 Reputazione

1 Guida realizzata

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 246