Unisciti alla Community delle riparazioni - Crea un account

Introduzione

This page gives instructions for disassembling the Black and Decker WP900 6-Inch Orbital Waxer and Polisher to the point where the power cable can be fully removed and replaced.

Cosa ti serve

Passo 1 Power Cord

Black and Decker WP900 Power Cord Replacement, Power Cord: passo 1, immagine 1 di 1

Using the plastic tool, detach the handle tab as shown.
Make sure the device is unplugged.

Modifica

Passo 2

Using the Philips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.
Be sure to keep track of where each screw was placed in the device for later reassembly.

Modifica

Passo 3

Black and Decker WP900 Power Cord Replacement: passo 3, immagine 3 di 3

Remove the back panel of the external casing, leaving all internal components resting in the front panel.
Remove the black handle from the main external casing.

Modifica

Passo 4

Loosen the power cord and control panel. Using the Phillips #1 screwdriver, remove two 22mm screws.
The metal bracket will detach with the two screws.
Using the Flathead 3/32" screwdriver, remove two 22mm screws.

Modifica

Passo 5

Gently pull the power cord out from the control module.
This is the part to be replaced. Remember to insert the black wire into the top port when installing the new cord.