Aggiusta le tue cose Community Store
Unisciti alla Community delle riparazioni - Crea un account

Black and Decker WP900 Exterior Casing Replacement

Introduzione

This page gives instructions for disassembling the Black and Decker WP900 6-Inch Orbital Waxer and Polisher to where the external casing can be removed from all internal workings.

Cosa ti serve

  1. Black and Decker WP900 Exterior Casing Replacement, Exterior Casing: passo 1, immagine 1 di 1

    • Using the plastic tool, detach the handle tab as shown.

    • Make sure the device is unplugged.

    Modifica

  2. Black and Decker WP900 Exterior Casing Replacement: passo 2, immagine 1 di 1

    • Using the Phillips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.

    • Be sure to keep track of where each screw was placed in the device for later reassembly.

    Modifica

  4. Black and Decker WP900 Exterior Casing Replacement: passo 3, immagine 1 di 3 Black and Decker WP900 Exterior Casing Replacement: passo 3, immagine 2 di 3 Black and Decker WP900 Exterior Casing Replacement: passo 3, immagine 3 di 3

    • Remove the back panel of the external casing, leaving all internal components resting in the front panel.

    • Remove the black handle from the main external casing.

    Modifica

  5. Black and Decker WP900 Exterior Casing Replacement: passo 4, immagine 1 di 1

    • Using the Phillips #1 screwdriver, remove the two 22mm screws.

    • The metal bracket will detach with the two screws.

    • Using the Flathead 3/32" screwdriver, remove two 22mm screws.

    Modifica

  6. Black and Decker WP900 Exterior Casing Replacement: passo 5, immagine 1 di 2 Black and Decker WP900 Exterior Casing Replacement: passo 5, immagine 2 di 2

    • Gently pull the power cord out from the control module.

    • Remember, when reassembling the device, the black wire should be on the top.

    Modifica

  7. Black and Decker WP900 Exterior Casing Replacement: passo 6, immagine 1 di 1

    • Firmly grasping the motor dislodge the internal components from the frontal external casing.

    • Once the motor has been removed, the external casing can now be replaced.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 3 altri collaboratori

David Hutchings

Membro da: 03/28/16

101 Reputazione

1 Guida realizzata

Distintivi: 2

1Commento della guida

Hello, this is Adam Kinnett from Group 7. You have done an excellent job on your photos as well as the descriptions and formatting.

**One of your Wiki pages on the search says "Back and Decker".

Adam Kinnett - Rispondi Condividi

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 13

Ultimi 30 Giorni: 54

Tutti i Tempi: 1,299