Aggiusta la tua roba Comunità Store

Black and Decker DustBuster 15.6V Nozzle Brush Replacement

Introduzione

The nozzle brush located on the end of shaft may break off during the cleaning process. Replacing the brush is as easy as breaking it off.

Cosa ti serve

  1. Black and Decker DustBuster 15.6V Nozzle Brush Replacement, Nozzle Brush: passo 1, immagine 1 di 1

    • Lift Nozzle Brush until it clicks into fully erect position.

    Modifica

  2. Black and Decker DustBuster 15.6V Nozzle Brush Replacement: passo 2, immagine 1 di 1

    • Apply a gentle, equal pressure outward, to the inside of both brush legs.

    Modifica

  4. Black and Decker DustBuster 15.6V Nozzle Brush Replacement: passo 3, immagine 1 di 1

    • Remove one of the leg prongs from the hole it is inserted into.

    Modifica

  5. Black and Decker DustBuster 15.6V Nozzle Brush Replacement: passo 4, immagine 1 di 1

    • Rotate the free leg forwards or backwards from the hole.

    • This relieves the pressure from the inside of the legs allowing you to freely remove the last leg from its hole.

    Modifica

  6. Black and Decker DustBuster 15.6V Nozzle Brush Replacement: passo 5, immagine 1 di 1

    • Check each leg hole for debris and clear whats needed.

    • Insert a leg of the new brush into the correct hole, so the brush will click into its erect position.

    • Slide the other leg into its respective hole.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 1 altro collaboratore

Jacob

Membro da: 03/15/17

101 Reputazione

1 Guida realizzata

Distintivi: 2

Team

UMass Dartmouth, Team S6-G1, Isaacson Spring 2017 Membro di UMass Dartmouth, Team S6-G1, Isaacson Spring 2017

UMASSD-ISAACSON-S17S6G1

4 Membri

9 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 15

Tutti i Tempi: 320