Salta al contenuto principale

Introduzione

This guide shows the users how to replace the Bissell PowerForce Compact vacuum belt using the tools and parts listed in this guide.

Ricambi

  1. Bissell PowerForce Compact Belt Replacement, Belt: passo 1, immagine 1 di 3 Bissell PowerForce Compact Belt Replacement, Belt: passo 1, immagine 2 di 3 Bissell PowerForce Compact Belt Replacement, Belt: passo 1, immagine 3 di 3
    • Remove the 5 screws from the brush plate with the phillips screwdriver.

  2. Bissell PowerForce Compact Belt Replacement: passo 2, immagine 1 di 2 Bissell PowerForce Compact Belt Replacement: passo 2, immagine 2 di 2
    • Lift off the brush plate by grabbing both ends of the plate and lifting the plate up.

  3. Bissell PowerForce Compact Belt Replacement: passo 3, immagine 1 di 3 Bissell PowerForce Compact Belt Replacement: passo 3, immagine 2 di 3 Bissell PowerForce Compact Belt Replacement: passo 3, immagine 3 di 3
    • Grab the rotating brush at both ends.

    • Lift the rotating brush straight out of the vacuum.

    • Remove the belt from the motor pulley.

  4. Bissell PowerForce Compact Belt Replacement: passo 4, immagine 1 di 2 Bissell PowerForce Compact Belt Replacement: passo 4, immagine 2 di 2
    • Clear the bottom of the vacuum from any debris that may be blocking air flow.

    • Clean the rotating brush from any wrapped string or hair. You can use scissors if needed.

  5. Bissell PowerForce Compact Belt Replacement: passo 5, immagine 1 di 3 Bissell PowerForce Compact Belt Replacement: passo 5, immagine 2 di 3 Bissell PowerForce Compact Belt Replacement: passo 5, immagine 3 di 3
    • Check the new belt for any damage.

    • Place the belt on the rotating brush and then the motor pulley.

  6. Bissell PowerForce Compact Belt Replacement: passo 6, immagine 1 di 3 Bissell PowerForce Compact Belt Replacement: passo 6, immagine 2 di 3 Bissell PowerForce Compact Belt Replacement: passo 6, immagine 3 di 3
    • Pull the rotating brush with the belt hooked.

    • Place the ends of the rotating brush into the slots.

    • Rotate the brush a few times to center the belt.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 4 persone hanno completato questa guida.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 18

Ultimi 30 Giorni: 167

Tutti i Tempi: 3,233