Introduzione

The casing and structure of Beats by Dre Studio 2.0 over-ear headphones directly influence their sound quality. When the interior side panel is compromised, a proper seal (to one's ears) is not achievable, and ultimately sound quality is severely lessened. This guide will provide thorough instructions on how to replace the interior side paneling and restore optimal sound quality.

  1. Use metal spudger to pry away ear cushion.
    • Use metal spudger to pry away ear cushion.

  2. Remove ear cushion from headphones (attached by adhesive).
    • Remove ear cushion from headphones (attached by adhesive).

    • Remove two screws from the metal hinge using a Phillips head screwdriver to allow more motion from the speaker housing and more accessibility.

    • Remove five screws using a Phillips head screwdriver from speaker housing.

    • Pull speaker away to access second secondary housing.

    • Be careful not to stress wires and break solder points.

    • Raise center cover.

    • Remove screw from center of housing.

    • Pull secondary housing away gently being careful not to damage the wires.

    • Remove four screws using a Phillips head screwdriver to remove the third housing.

    • Disconnect wires gently.

    • Be gentle with the wires ensuring to pull them through with care to eliminate possible shortages.

    • Pass wire through new housing and reconnect wires.

    • Snap housing into place.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Antares Cam

Membro da: 27/02/2018

221 Reputazione

1 Guida realizzata

Team

colby and cameron Membro di colby and cameron

Community

2 Membri

1 Guida realizzata

Visualizza Statistiche:

Ultime 24 Ore: 4

Ultimi 7 Giorni: 26

Ultimi 30 Giorni: 107

Tutti i Tempi: 884