Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the device off by holding down the power button for up to 5 seconds and then tapping the "Power off" button on the screen.
-
Remove the rear cover using your hands at the lip on the device back cover. No tools required.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove twelve 3mm Phillips #000 screws from the rear plate.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the plastic frame on the device using an opening tool.
-
Firmly press the tool into the gap between the front glass and rear plate.
-
Run the tool through this gap along the entire edge of the phone to separate the plastic frame from the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect lower PCB antenna connection.
-
Disconnect lower PCB data cable connection.
-
Remove the single JIS #000 3mm screw from the PCB board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the haptic motor at bottom left of the device. This will require a prying tool, as the motor is glued to the device.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.