BLU Life X8 Daughterboard Replacement

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

The daughterboard is connected to the bottom speaker, the USB port, and the touch screen, so if one of these isn't functioning properly the daughterboard may need to be replaced. This guide explains how to access, remove, and replace the daughterboard of your BLU Life X8.

Cosa ti serve

Passo 1 Battery

BLU Life X8 Daughterboard Replacement, Battery: passo 1, immagine 1 di 2

BLU Life X8 Daughterboard Replacement, Battery: passo 1, immagine 2 di 2

Flip the phone over so that the screen is facing down.
Slide the opening tool between the micro-USB port and the back cover.
Use the opening tool to create a gap.

Traduci

Passo 2

Use your thumb to pry off the back panel once the gap is large enough.

Traduci

Passo 3

Once the back panel is off, locate the indent at the bottom of the battery.
Use your thumb to slip the battery out of the case.

Traduci

Passo 4 Motherboard

BLU Life X8 Daughterboard Replacement, Motherboard: passo 4, immagine 1 di 2

BLU Life X8 Daughterboard Replacement, Motherboard: passo 4, immagine 2 di 2

Use the Phillips #00 bit to undo the nine 1.5mm screws from the back of the device.

Traduci

Passo 5

Wedge the opening tool into the seam of between the screen and the gray frame.
Run the opening tool along the seam to release the clips that hold the two pieces together.
You may need to use the opening picks to prevent the clips from re-engaging.

Traduci

Passo 6

Once all the clips have been released, lift the frame and set it aside.

Traduci

Passo 7

Use the Phillips #00 Phillips bit to undo the two 1.5mm screws from the motherboard.

Traduci

Passo 8

BLU Life X8 Daughterboard Replacement: passo 8, immagine 3 di 3

Use the tweezers to peel away the mesh tape and reveal the ribbon connectors.
Use the tweezers to lift the brown and black tabs to release the ribbon cables and unlock them.

Traduci