BLU Life X8 Back Camera Replacement

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

The back camera may become damaged or scratched over time, causing poor quality pictures. This guide will explain how to access, remove, and replace your BLU Life X8 back camera.

Cosa ti serve

Passo 1 Battery

BLU Life X8 Back Camera Replacement, Battery: passo 1, immagine 1 di 2

BLU Life X8 Back Camera Replacement, Battery: passo 1, immagine 2 di 2

Flip the phone over so that the screen is facing down.
Slide the opening tool between the micro-USB port and the back cover.
Use the opening tool to create a gap.

Traduci

Passo 2

Use your thumb to pry off the back panel once the gap is large enough.

Traduci

Passo 3

Once the back panel is off, locate the indent at the bottom of the battery.
Use your thumb to slip the battery out of the case.

Traduci

Passo 4 Back Camera

BLU Life X8 Back Camera Replacement, Back Camera: passo 4, immagine 1 di 2

BLU Life X8 Back Camera Replacement, Back Camera: passo 4, immagine 2 di 2

Use the Phillips #00 (1.5mm) bit to undo the (9) screws from the back of the device.

Traduci

Passo 5

Wedge the opening tool into the seam of between the screen and the gray frame.
Run the opening tool along the seam to release the clips that hold the two pieces together.
You may need to use the opening picks to prevent the clips from reengaging.

Traduci

Passo 6

Once all the clips have been released, pull back the frame and set it aside.

Traduci

Passo 7

Use the tweezers to unlock the ribbon cable from the motherboard
The ribbon cable should be free. Pull back on the ribbons to release it from the connector

Traduci