Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Introduzione

This guide provides information on how to remove and replace the hook and loop system of the BLACK and DECKER BDERO100 5 inch sander. The only tool that you will need for this process is the JIS - J1 bit or equivalent.

Parti

Nessuna parte specificata.

  1. Remove the sanding paper from the velcro.
    • Remove the sanding paper from the velcro.

  2. Select the JIS - J1 bit or the most appropriate bit to match the screws for your model.
    • Select the JIS - J1 bit or the most appropriate bit to match the screws for your model.

  3. Use the Bit Driver to take off the four 12.5 mm Phillips screws at the base of the hook-and-loop system. Be careful not to lose the lock washers (black rings).
    • Use the Bit Driver to take off the four 12.5 mm Phillips screws at the base of the hook-and-loop system.

    • Be careful not to lose the lock washers (black rings).

  4. Once all screws and washers have been removed, hold the hook and loop system and separate it from the device. Once all screws and washers have been removed, hold the hook and loop system and separate it from the device.
    • Once all screws and washers have been removed, hold the hook and loop system and separate it from the device.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Christian Moss

Membro da: 10/02/2016

101 Reputazione

1 Guida realizzata

Team

USF Tampa, Team 1-5, Sullivan Spring 2016 Membro di USF Tampa, Team 1-5, Sullivan Spring 2016

USFT-SULLIVAN-S16S1G5

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 24

Tutti i Tempi: 737