Aggiusta la tua roba Comunità Store

Atari Lynx Backlight Replacement

Introduzione

Before starting this guide you may need some experience with soldering/ desoldering. If you do not know how, you can learn by clicking the link we put on step 8 (when you have to desolder the backlight).

Cosa ti serve

  1. Atari Lynx Backlight Replacement, Atari Lynx: passo 1, immagine 1 di 1

    • Before disassembling your Atari Lynx, be sure the device is powered off.

    • Remove any game in the console by opening the right latch and sliding the game to the right.

    Modifica

  2. Atari Lynx Backlight Replacement: passo 2, immagine 1 di 1

    • Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.

    • Pinch the rear panel with your fingers and lift away from the Atari.

    Modifica

  3. Atari Lynx Backlight Replacement: passo 3, immagine 1 di 1

    • Remove the battery panel by pinching the sides with your fingers and lifting it away from the Atari.

    • Be sure not to tear any wires attached to battery panel.

    Modifica

  5. Atari Lynx Backlight Replacement: passo 4, immagine 1 di 1

    • Remove the control panel by pinching the sides with your fingers and lifting it away from the Atari.

    • Be sure not to tear the speaker wire while removing the control panel.

    Modifica

  6. Atari Lynx Backlight Replacement, Backlight: passo 5, immagine 1 di 1

    • Pull out the logic-board.

    • Pull to the sides the four rubber tabs holding in the screen

    Modifica

  7. Atari Lynx Backlight Replacement: passo 6, immagine 1 di 1

    • Unscrew the two 10 mm screws as shown with a Phillips #0 screwdriver in order to remove the shield behind the backlight.

    Modifica

  8. Atari Lynx Backlight Replacement: passo 7, immagine 1 di 1

    • Flip over the motherboard and remove the shield behind the backlight.

    Modifica

  9. Atari Lynx Backlight Replacement: passo 8, immagine 1 di 2 Atari Lynx Backlight Replacement: passo 8, immagine 2 di 2

    • Flip the motherboard back over and desolder the two components that are holding the backlight in place.

    • If you need help with basic desoldering, click here.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Autore

con 5 altri collaboratori

John Lopez

Membro da: 01/27/14

443 Reputazione

4 Guide realizzate

Distintivi: 9

+6 altri distintivi

Team

Cal Poly, Team 1-42, Maness Winter 2014 Membro di Cal Poly, Team 1-42, Maness Winter 2014

CPSU-MANESS-W14S1G42

5 Membri

16 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 26

Tutti i Tempi: 4,346