Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Atari Flashback 2 Console Power Button Replacement

Cosa ti serve

  1. Atari Flashback 2 Console Power Button Replacement, Console Power Button: passo 1, immagine 1 di 3 Atari Flashback 2 Console Power Button Replacement, Console Power Button: passo 1, immagine 2 di 3 Atari Flashback 2 Console Power Button Replacement, Console Power Button: passo 1, immagine 3 di 3
    • Using the screwdriver and PH1 bit, unscrew the five 10.0 mm screws.

    • One is under the main sticker in the middle of the console.

  2. Atari Flashback 2 Console Power Button Replacement: passo 2, immagine 1 di 3 Atari Flashback 2 Console Power Button Replacement: passo 2, immagine 2 di 3 Atari Flashback 2 Console Power Button Replacement: passo 2, immagine 3 di 3
    • Use a PH1 screwdriver to unscrew the two 9.0 mm screws on the circuit board that corresponds to the red power button.

    • Remove gently. The circuit board is connected by wire to the console. Removing the cable from the console case may allow more slack.

    • A spring may pop out.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Faith Julian

Membro da: 09/18/18

205 Reputazione

2 Guide realizzate

Team

Un commento

Hello. I just bought a used atari flashback 2 and when I turn it on it seems that the power button is a little tricky. I wiggle the button in and out and half way etc. then sometimes I can get it to turn on. Once on, the video 'pulses' on and off and a pulsing sound is noticeable. Is it just a faulty power button or is it something worse like a power regulator. I've taken it apart and all seems to be ok looking ie. no burnt fuses etc.  Can you help?  ~Brad Beachin~

bradbeachin - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 9

Tutti i Tempi: 773