Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the laptop upside-down and remove the following screws using a Phillips #0 driver:
-
Two 9.5 mm screws in the middle of the back edge, and one 9.5 mm screw in the right edge
-
Two 4.3 mm screws in the back corners
-
One 17.5 mm screw at the left edge near the optical drive
-
Three 4.3 mm screws in the front edge
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the plastic opening tool to separate the keyboard plate cover from the bottom cover. In order to do this, insert the plastic opening tool in between the keyboard plate cover and the bottom cover, then slide along edges to pry open.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the three ribbons connecting the keyboard plate cover to the bottom cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Invert the laptop in order to gain access to the ribbons.
-
Remove each ribbon by flipping the small white plastic flap up and gently pulling on the ribbon.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Now that the ribbons have been detached from the bottom cover, carefully remove the keyboard plate cover. Once it has been removed, place it in a safe and moisture free area so it does not get damaged.
-
Annulla: non ho completato questa guida.
Altre 11 persone hanno completato questa guida.
2 Commenti
WARNING the screw lengths in step 1 are wrong. I tried installing the wrong screws and now my touch pad us ruine
The screw info has been updated. I’m still not sure if it’s 100% correct, so be sure to keep your screws organized and put each one back where it came from to avoid damage.