Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Power down the laptop using the device's power button in top right corner of the keyboard. Ensure that the device's power cord is disconnected.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the laptop over so the back panel is displayed.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a Phillips #1 screwdriver, remove the ten screws from the back panel.
-
Remove the two battery screws (15.6 mm)
-
Two top corner screws (12.5 mm)
-
Six case screws (9.7mm)
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the laptop back over and open it, revealing the screen and keyboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the blue plastic opening tool, wedge and loosen the seal all the way around the edges. Carefully lift up the keyboard panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Observe where the ribbons connect to the motherboard, there are two connections. Each connection has a black clamp. To remove the ribbon, lift the black clamp up to disconnect it.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Very carefully, remove the batteries with the blue plastic iFixit opening tool. Focus removing the battery near the highlighted area.
-
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.
Un commento
Easy, and nice guide.
To be honest you don't need make pint 6 - unplug keyboard and pad cable. You can just move cover a bit to your side (pull into your direction) then you will get a lot space to pull out battery.